$24.99  $14.99  2+  $13.00 10+  $12.50 25+  $11.00 50+  $9.00 100+  $8.00 Quantity available: 112 In Stock: Usually ships next business day. -  Jiasudu Homepage -  Other products

Brand New Satellite Finder In a Box

WE ONLY SELL ORIGINAL JIASUDU, NO COPYCATS

This is simple and fast-use small sized satellite finder. It is used to adjust the installation and fixing of satellite antenna. It is Elegant looking and pocket size (attention: Please dont close to metal objects while using).
It can find satellite signal accurately via satellite antenna and figure antenna azimuth angle and elevation angle out. It uses theodolite to locate antenna properly and then displays frequency signal magnitude. Continuously, adjusting azimuth angle and elevation angle with high precision, antenna will receive max signal intensity.
 

Characteristics:
1.75Ω BS type F outlet.
2. Inside installed micro lamp and buzzer.
3. Input frequency. 950---2250MHz.
4. Min. Input level: -40dBm.
5. Max. Input level: -10dBm.
6. Power supply: 13--18VDC

Technical parameters:
Frequency range  0.95GHz-2.15GHz
Gain  11dB
Sensitivity  7
Power supply  DC13-18V
LNB gain  52-60dB

User guidance.
1. Installation and operation.
1). Use cable to connect satellite finder port and LNB port.
2). Connect "TO REC" port of finder to satellite receiver.
3). Make sure all above connections all right, turn on power and satellite receiver, micro lamp shines and pointer is swinging around position 1.
4). Adjust antenna azimuth angle and elevation angle to locate antenna accurately towards satellite location.
5). Adjust spiral button on front panel of finder to let pointer swinging around position 5.
6). Adjust antenna position, remnant power and LNB polarized angle until the pointer reaches utmost. Contra rotate spiral button and lower indicating value down until the value is not increasing.
7). Take satellite finder off and connect receiver to LNB.
2. Remarks.
1). In order to avoid the condition that finder reaches always to max value, please don't put finder in front of antenna.
2). While Using high plus LNB (plus value is over 60dB), you can connect an attenuator (attenuation value is 5 dB) between LNB and finder or use 6 meter length RG-59U cable instead of the attenuator.
3). If pointer wobbles all the time, that means the sensitivity is too high. You can clockwise adjust inside S. A spiral button to turn the sensitivity down.